Regularly check whether the connection between the electric furnace and the connector of the controller is good.
Electric furnaces and controllers* shall operate in locations where the relative humidity does not exceed 85% and there are no conductive dust, explosive gases and corrosive gases that can damage metal insulation and electronic components.
The operating environment temperature of the controller is limited to 0-50 °C.
When the electric furnace and the controller are used, the rated power shall not be exceeded, the furnace temperature shall not exceed the * high use temperature, it is forbidden to load the wet workpiece into the furnace, and the heated workpiece containing high moisture should be dried in advance.
Keep the inside of the furnace clean, remove the metal oxides, slag and impurities in the furnace in time, and be cautious when loading and unloading the workpiece to prevent damage to the silicon carbon rod.
The silicon carbon rod should be placed in a dry place to prevent the aluminum head from deteriorating due to moisture. If the existing rod is white and some dark red during use, it means that the resistance of each rod changes differently, and it is necessary to replace it with a rod with a similar resistance value and then reuse.
Silicon carbon rod is a recrystallization product of silicon carbide, alkali, alkali metal, sulfuric acid and boron compounds at high temperature can corrode it, water vapor has a strong oxidation effect on it: hydrogen and gas containing a large amount of hydrogen will decompose silicon carbon rod at high temperature, and strict attention must be paid to the use.
Scan code to obtain product plans and quotations